Dakota Digital SIM-1-GSXR Manual

Changing the gearing or tire size the gearing or tire size on a motorcycle will make the speedometer
incorrect. The SIM-1-GSXR will allow you to adjust
speed sensors, back to the correct reading , back to the correct reading.
The SIM-1-GSXR has an adjus
to 0.502 times (half). Calibration is set using the two push button switches. Press the UP button to
increase the speed. Press the DOWN button to decrease the speed. The unit has an internal increase the speed. Press the DOW
memory which stores the calibration when the bike is turned off, or if the unit is memory which stores the calibrat
work/service on the bike.
*Depending how far off your speedometer is
on your speedometer with the SIM-1-GSXR installed until you are traveling faster than 5 on your speedometer with the SIM
miles per hour.
Typical GSXR Install (3-pin speed sensor
Connection is as follows:
1. Locate the three pin connector between the speedometer and speed sensor
black connector. You will need to remove the seat and lift the tank to locate the
under the tank at the back side of the engine with some of the other wiring. under the tank at the back side of the engine with some of the other wiring. (image 1 and 2) under the tank at the back side of the engine with some of the other wiring.
2. Unplug the connector.
3. Plug the SIM-1-GSXR into the two mating connectors. The SIM
between the speedometer and speed sensor. (image 3) between the speedometer and speed sensor. (
4. Re-assemble any removed pieces and leave the SIM any removed pieces and leave the SIM-1-GSX accessible for calibration
steps below).
5. Once calibrated secure the SIM
Wire ties work well for this. There is a small space in front of the battery Wire ties work well for this.
good spot for mounting (image
SPEED RECALIBRATION UNIT
FOR SUZUKI ELECTRIC SPEEDOMETERS FOR
will allow you to adjust an electronic speedometer,
has an adjustable range of correction from 2.84 times
Calibration is set using the two push button switches. Press the UP button to Calibration is set using the two push button switches. Press the UP button to
ion when the bike is turned off, or if the unit is unplugged for any
how far off your speedometer is, you may NOT register a speed reading
speed sensor connectors)
connector between the speedometer and speed sensor connector between the speedometer and speed sensor, typically it is a
You will need to remove the seat and lift the tank to locate the You will need to remove the seat and lift the tank to locate the connector; it is
Image 1
into the two mating connectors. The SIM-1-GSXR
ecure the SIM-1-GSXR into the harness on the bike so it is not hanging loose.
(image 4).
SIM-1-GSXR
an electronic speedometer, with stock electric
until you are traveling faster than 5
GSX accessible for calibration (see
into the harness on the bike so it is not hanging loose.
speedometer reading
times (more than double)
The unit has an internal
register a speed reading
Image 2 Image 2
GSXR will now be in
under the seat that is a
MAN#650310