Configuring Aaa And Radius Settings; Table 7. Global Radius Server - D-Link DWS-3024 User Manual

switch or externally on a RADIUS server. When an AP is discovered, the switch verifies the
AP's MAC address according to the validation mode (local or RADIUS) as long as the AP is
enabled for Managed Mode and has been authentication (if required). Once the AP is verified,
it becomes managed by the switch.
If an AP is discovered and its MAC address is not found in the Valid AP database or the AP
fails to authenticate, the switch adds an entry to the AP failure list. If you use the local Valid
AP database, you can add the failed AP to the Valid AP database directly from the AP
Authentication Failures page.
The Valid AP database stores additional information about the AP along with its MAC address
such as the AP mode, local authentication password, and the AP profile that the access point
uses. You can also manually set the channel and RF signal transmit power level for an
individual AP, which overrides the channel and power settings in the AP profile.

Configuring AAA and RADIUS Settings

In the D-Link Unified Access System, you can use a RADIUS server for the following
functions:
• Management of client-to-AP authentication and accounting
• Management of AP-to-Switch authentication and accounting
• Database for AP settings
The information in this section applies to the client-to-AP authentication and accounting
management. For information about AP-to-switch management, see
Database for AP Validation"
settings in the RADIUS server, see Appendix B,
on page 207.
The RADIUS server that you configure from the Administration > Basic Setup >
AAA/RADIUS tab is the RADIUS server for the default AP profile. For each network, you
can configure a unique RADIUS server or use the default RADIUS server.
When you use a RADIUS server for wireless client-to-AP communications, such as when
clients use WPA Enterprise or WEP IEEE 802.1X security to connect to the AP, the AP is the
RADIUS client and communicates with the RADIUS server. The Unified Switch does not
tunnel packets between the AP and RADIUS server. This means that you must configure the
AP as a client in the RAIDUS server. For information about how configure RADIUS clients,
see Appendix B.
Table 7 describes the fields you can configure for the default AP profile RADIUS server.

Table 7. Global RADIUS Server

Field Description
IP Address This is the IP address of the
on page 78. For information about how to set AP database
"Configuring the External RADIUS Server"
RADIUS server the AP uses for authentication.
5 Configuring Access Point Settings
"Using the RADIUS
Configuring AAA and RADIUS Settings 85