Creating The Vlan Routing Interface - D-Link DWS-3024 User Manual

D-Link Unified Access System User Manual
1. Log on to the CLI and switch to Global Config mode:
(System-Prompt)
User: admin
Password:
(System-Prompt) >enable
Password:
(System-Prompt) #config
(System-Prompt) (Config)#
2. Enable routing.
(System-Prompt) (Config)#ip routing
3. Change to Interface Config mode for loopback interface 0, and assign an IP address and
subnet mask.
(System-Prompt) (Config)#interface loopback 0
(System-Prompt) (Interface loopback 0)#ip address 192.168.100.15 255.255.255.255
You can also use the Web interface or SNMP to enable routing and configure an IP address.
The following example shows the procedures to enable routing and configure an IP address on
the switch by using the Web interface.
1. Log on to the Web interface and click Routing > IP > Configuration to access the IP
Configuration page.
2. From the Routing Mode drop-down menu, choose Enable, and then click Submit.
3. To create a loopback interface, click Routing > Loopback > Configuration.
4. From the Loopback drop-down menu, choose Create, and then click Submit
5. Enter an IPv4 address and subnet mask in the appropriate fields, and then click Submit.

Creating the VLAN Routing Interface

The D-Link Unified Switch and the D-Link Access Point support Virtual LANs (VLANs) to
provide the logical separation of a physical network. You can use VLANs to segment the
wireless network on a per-VAP basis. VLAN routing interfaces allow VLANs to span across
different subnets, which is useful for L3 Tunneling.
In Figure
following commands show how to configure the interface for WS1, which has a VLAN
Routing interface with VLAN ID 200 and an IP address of 192.168.60.15.
1. Enter VLAN config mode, create a VLAN, and give it a name.
(switch-prompt) #vlan database
(switch-prompt) (Vlan)#vlan 200
(switch-prompt) (Vlan)#vlan name 200 "L3 Tunnel"
2. Create a VLAN routing interface on VLAN 200.
(switch-prompt) (Vlan)#vlan routing 200
218 © 2001- 2008 D-Link Corporation. All Rights Reserved.
103, WS1 and WS2 have a VLAN routing interface on the L3 Tunnel subnet. The