Configuring Global Captive Portal Settings; Figure 76. Global Captive Portal Configuration; Table 56. Global Captive Portal Configuration - D-Link DWS-3024 User Manual

D-Link Unified Access System User Manual

Configuring Global Captive Portal Settings

Use the CP Global Configuration page to control the administrative state of the CP feature
and configure global settings that affect all captive portals configured on the switch.
To configure the global CP settings, click Security > Captive Portal > Global
Configuration.

Figure 76. Global Captive Portal Configuration

Table 56

Table 56. Global Captive Portal Configuration

Field
Enable Captive
Portal
CP Global
Operational Status
CP Global Disable
Reason
Additional HTTP
Port
Authentication
Timeout
168 © 2001- 2008 D-Link Corporation. All Rights Reserved.
describes the global CP fields you can view or configure.
Description
Select the check box to enable the CP feature on the switch. Clear the check
box to disable the captive portal feature.
Shows whether the CP feature is enabled.
If CP is disabled, this field displays the reason, which can be one of the
following:
• None
• Administratively Disabled
• No IPv4 Address
• Routing Enabled, But no IPv4 routing interface
HTTP traffic uses port 80, but you can configure an additional port for HTTP
traffic. Enter a port number between 0-65535 (excluding port 80).
To access the network through a portal, the client must first enter
authentication information on an authentication Web page. Enter the number
of seconds to keep the authentication session open with the client. When the
timeout expires, the switch disconnects any active TCP or SSL connection
with the client.