Using The Local Database For Ap Validation; Figure 36. Requiring Ap Authentication - D-Link DWS-3024 User Manual

D-Link Unified Access System User Manual
To enable AP authentication on the Unified Switch, click Administration > Basic Setup.
From the Global tab, check the AP Authentication box, then click Submit to apply your
changes.

Figure 36. Requiring AP Authentication

To enable AP authentication from the CLI, access Wireless Config mode and enable
authentication:
(switch-prompt) >enable
Password:
(switch-prompt) #config
(switch-prompt) (Config)#wireless
(switch-prompt) (Config-wireless)#ap authentication

Using the Local Database for AP Validation

To use the local Valid AP database, set the AP MAC Validation to local, add APs to the
database, and configure the settings for the APs in the database. All of the configuration takes
place on the switch.
To set up the local database for AP MAC Validation, use the following steps:
1. From the Administration > Basic Setup > Global page, make sure AP MAC Validation
is set to Local, which is the default.
2. Click Submit if you made any changes.
3. Click the Valid AP tab.
76 © 2001- 2008 D-Link Corporation. All Rights Reserved.