Now tighten the two screws at adjacent ends of the module into the available screw holes on
the Switch. The upgraded Switch is now ready for use.
Figure 26. DWS-3026 with optional DEM-410X module installed
Connecting to the External Redundant Power System
The Switch supports an external redundant power system (RPS). The diagrams below
illustrate a proper RPS power connection to the Switch. Please consult the documentation for
information on power cabling and connectors and setup procedure.
Figure 27. RPS Connector
DWS-3026
DPS-600
Connecting the Switch
This section describes how to connect the following nodes:
•
Switch to the network
•
AP directly to the Switch
•
AP to the Switch through the L2/L3 network
•
Switch through the 10GB uplink to the network core
All 24 high-performance N-Way Ethernet ports can support both MDI-II and
NOTE:
MDI-X connections.
3 Installing the Hardware
RPS Connector
Connecting the Switch
49