D-Link DWS-3024 User Manual page 90

D-Link Unified Access System User Manual
Table 9. Radio Settings
Field
Station Isolation
Rate Sets
Basic
Supported
Mode
Maximum Clients
90 © 2001- 2008 D-Link Corporation. All Rights Reserved.
Description
Select the check box to enable Station Isolation, or clear it to disable station
isolation.
• Enabled: Access point blocks communication between wireless clients.
The access point still allows data traffic between its wireless clients and
wired devices on the network, but not among wireless clients.
• Disabled: Wireless clients can communicate with one another normally
by sending traffic through the access point.
Note: Station Isolation is operational only for clients that transmit non-
tunneled traffic. When client traffic is tunneled, Station Isolation is not in
effect for those clients even if it is enabled.
Note: Station Isolation is configured independently for each radio. You
cannot configure Station Isolation on a per-SSID or per-AP basis.
Check the transmission rate sets you want the access point to support and the
basic rate sets you want the access point to advertise.
Rates are expressed in megabits per second.
These numbers indicate rates that the access point will advertise to the
network for the purposes of setting up communication with other APs and
client stations on the network. It is generally more efficient to have an AP
broadcast a subset of its supported rate sets.
These numbers indicate rates that the access point supports. You can check
multiple rates (click a check box to select or de-select a rate). The AP
automatically chooses the most efficient rate based on factors like error rates
and distance of client stations from the AP.
The Mode defines the Physical Layer (PHY) standard the radio uses.
The DWL-3500AP and Radio 1 on the DWL-8500AP use the IEEE 802.11g
mode PHY standard. This mode is a higher speed extension (up to 54 Mbps)
to the 802.11b PHY, while operating in the 2.4 GHz band. It uses orthogonal
frequency division multiplexing (OFDM). It supports data rates ranging from
1 to 54 Mbps. IEEE 802.11b clients can use the 802.11g mode.
Radio 2 on the DWL-8500AP use the IEEE 802.11a mode, which is a PHY
standard that specifies operating in the 5 GHz U-NII band using orthogonal
frequency division multiplexing (OFDM). It supports data rates ranging from
6 to 54 Mbps.
If the radio state is disabled, the mode displays as Off.
Specify the maximum number of stations allowed to access this access point
at any one time.
You can enter a value between 0 and 256.