Factory Reset - D-Link DES-3624 Series User Manual

The computer will be rebooted once you press RESTART.

Factory Reset

Before performing a Factory Reset, be absolutely certain that this is what you want to do. Once the reset is
done, all of the Switch's settings stored in NV-RAM (including TCP/IP parameters, SNMP parameters, the
enabled/disabled settings of ports, security settings, etc.) will be erased and restored to values present when
the Switch was purchased.
Note: After performing the Factory Reset, make sure to redefine the IP settings for the Switch in the
Configure IP Address menu. Then perform a Restart System on the Switch. After these three
procedures are performed, your Factory Reset is complete.
Choose Factory Reset from the main menu. The following screen appears:
102
Figure 6-63. Restart System screen
Stackable NWay Ethernet Switch User's Guide
Using the Console Interface