Performance Features; Management - D-Link DES-3624 Series User Manual

Stackable NWay Ethernet Switch User's Guide
♦ Gigabit uplink/MDI-II (media dependent interface) slide-in module in the rear panel for uplink to
another Switch. One-port or two-port models are available (DES-3624i, DES-3624iF, and DES-3624iFM
only).
♦ RS-232 DCE console port for diagnosing the Switch via a connection to a PC and Console/Out-of-band
management (DES-3624i, DES-3624iF, or DES-3624iFM only).
♦ One slide-in module interface in the front panel for 1 or 2 ports 10/100M Ethernet connection. Three
optional modules are available: 2-port TX, 2-port FX (MT-RJ), and 1-port FX (SC).
♦ Stacking Input/Output port slide-in module in the rear panel for stacking to another device to
implement a high-port count, manageable switch. Three-port module for master device and one-port
module for a client

Performance features

♦ Store and forward switching scheme capability to support rate adaptation and protocol conversion.
♦ Full- and half-duplex for 10Mbps and 100Mbps connections. The optional 1000BASE-SX and
1000BASE-LX modules operate at full-duplex only. The optional 1000BASE-T module, however, can be
negotiated to 1000M/half.
♦ Auto polarity detection and correction of incorrect polarity on the receive twisted pair at each port.
♦ Data forwarding rate 14,880 pps per port at 100% of wire-speed for 10Mbps speed.
♦ Data forwarding rate 144,810 pps per port at 100% of wire-speed for 100Mbps speed.
♦ Data forwarding rate 1,488,100 pps per port at 100% of wire-speed for 1000Mbps speed.
♦ Data filtering rate eliminates all error packets, runts, etc. at 14,880 pps per port at 100% of wire-speed
for 10Mbps speed.
♦ Data filtering rate eliminates all error packets, runts, etc. at 144,810 pps per port at 100% of wire-
speed for 100Mbps speed.
♦ Data filtering rate eliminates all error packets, runts, etc. at 1,488,100 pps per port at 100% of wire-
speed for 1000Mbps speed.
♦ 12K active MAC address entry table per device with automatic learning and aging (10 to 9999 seconds).
♦ 12 MB packet buffer per device.
♦ Supports Broadcast Storm filtering.
♦ Supports IGMP Multicast snooping.

Management

♦ RS-232 console port for out-of-band network management via a console terminal or PC.
♦ Spanning Tree Algorithm Protocol for creation of alternative backup paths and prevention of indefinite
network loops.
♦ Fully configurable either in-band or out-of-band control via SNMP based software.
Introduction
device.
13