D-Link DES-3624 Series User Manual page 57

Stackable NWay Ethernet Switch User's Guide
4. Enter the Bridge Max Age in the Max Age (6-40 sec.) field.
5. Enter the Bridge Hello Time in the Hello Time (1-10 sec.) field.
6. Enter the Bridge Forward Delay time in the Forward Delay (4-30 sec.) field.
7. Enter the Bridge Priority in the Bridge Priority (0–65535) field.
The information on the screen is described as follows:
♦ Spanning Tree Protocol Select Enabled to implement the Spanning Tree Protocol.
♦ Time Since Topology Change (sec.) Read-only object displays the last time changes were made to
the network topology. These changes usually occur when backup paths are activated due to primary
path failures.
♦ Topology Change Count Read-only object displays the number of times (since the current
management session with the device was started) changes were made to the network topology.
Changes usually occur on the network when backup paths are activated.
♦ Designated Root Read-only object displays the MAC (Ethernet) address of the bridge/switch on the
network that has been chosen as the STP root.
♦ Root Cost Read-only object displays the cost for the path between the switch and the root bridge. If
the switch is the root bridge, then the root cost is zero.
♦ Root port Read-only object identifies the port (on the bridge) that offers the least path cost from the
bridge to the root bridge. In the event of a network loop, data packets will pass through the root port.
♦ Max Age (sec.) Read-only object indicates the maximum age of STP information learned from the
network (on any port) before it is discarded.
♦ Forward Delay (sec.) Read-only object indicates how fast any port on the bridge can change its
spanning state when moving towards the forwarding state. The value determines how long the port
stays in each of the listening and learning states, which precede the forwarding state.
♦ Hold Time (sec.)
configuration BPDUs shall be transmitted by the bridge.
♦ Root Priority Read-only object displays the priority number of the root bridge of the Spanning
Tree. The value is used in conjunction with the bridge MAC address to set the bridge ID, which in
turn is used when determining the root bridge of a multibridged network. The root bridge is
responsible for processing data packets when network loops occur. The smaller the number set, the
higher the bridge priority is. The higher the bridge priority, the more chance the bridge has of
becoming the root bridge. A bridge priority ranges from 0 to 65535, with 0 being the highest priority.
♦ Max Age (6-40 sec.) Maximum Age is a read-write object that can be set from 6 to 40 seconds. At
the end of the Maximum Age, if a BPDU has still not been received from the Root ridge, your Switch
will start sending its own BPDU to all other switches for permission to become the Root Bridge. If it
turns out that your Switch has the lowest Bridge Identifier, it will become the Root Bridge.
♦ Hello Time (1-10 sec.) Hello Time is a read-write object that can be set from 1 to 10 seconds. This is
the interval between two transmissions of BPDU packets sent by the Root Bridge to tell all other
switches that it is indeed the Root Bridge. If you set a Hello Time for your Switch, and it is not the
Root Bridge, the set Hello Time will be used if and when your Switch becomes the Root Bridge.
♦ Forward Delay (4-30 sec.) The Forward Delay is a read-write object that can be set from 4 to 30
seconds. This is the time any port on the Switch spends in the listening state while moving from the
blocking state to the forwarding state.
Using the Console Interface
Read-only object displays the time interval during which no more than two
61