Notes About The Configuration File - TRENDnet TEG-S224M User Manual

CONFIG – Image file of switch settings created by the
settings backup procedure.
Image_file
path and filename for the file to be loaded into the switch. For
example, "
e:\3624\3624prom.tfp
quotes are used as in the example file below.
– This is the IP address that will b e assigned to the
Ip_addr
switch. This
configuration settings file to another switch. The IP address
defined in this file will override the IP address in the
configuration settings file, thus the switch you are downloading
to can have a different IP address than the one that created the
configuration settings file. An example of an IP address is:
10.12.19.102
Subnet_mask
to the switch. An example of a subnet mask is:
Default_gateway
be assigned to the switch. An example of a default Gateway IP is:
10.254.254.253
# – Remark. When placed as the first character on a line, the
entire line will be ignored by the switch. This allows items to be
labeled, or unused commands to remain in the file so that the
syntax will not be forgotten.

Notes about the Configuration File:

This configuration file can only contain 4 settings:
Ip_addr, Subnet_mask
Each command can only appear once in the configuration file.
184
Stackable NWay Ethernet Switch User's Guide
– This command tells the switch the complete
command is included
.
– This is the subnet mask that will be assigned
– This is the default gateway IP that will
.
and
Default_gateway
". Make sure double-
for downloading
255.128.0.0
Code_type,
.
Sample Configuration File
a
.