TRENDnet TEG-S224M User Manual page 143

Stackable NWay Ethernet Switch User's Guide
2. Configure the Speed/Duplex setting for the port. Select
Auto for Auto-Negotiation. This allows the port to select the
best transmission speed and duplex mode based on the
capabilities of the device at the other end. Select 100/Full for
port operation at 100 Mbps and full duplex. Select 100/Half
for port operation at 100 Mbps and half duplex. Select
10/Full for port operation at 10 Mbps and full duplex. Select
10/Half for port operation at 10 Mbps and half duplex.
3. Configure the Flow Control setting for the port. Selecting
On in full-duplex mode will implement IEEE 802.3x flow
control. Selecting On when the port is in half duplex mode
will implement
backpressure flow control. Select Off for no flow control.
Also, if the port is set for Auto (NWay) in the speed/duplex
field above and flow control is enabled, flow control (whether
full- or half-duplex) will only be implemented if the other
device can auto-negotiate flow control. Note that you must
reboot the Switch before a flow control change can take
effect.
4. Configure the Locked setting to prevent the port from
learning the MAC addresses of new hosts. This will help
keep intruders off your network since any packet coming
from an unknown source address will be dropped by the
Switch, that is, not added to your MAC Address Forwarding
Table. Select Enabled or Disabled.
5. Configure the Priority setting for packets passing through
this port, using IEEE 802.1p/q tagging. Select Low, High or
Default. If the network is congested, the Switch handles
packets with a higher priority before those with lower
priority.
6. Configure the Rising Action setting under Broadcast
Storm from three choices: Do Nothing, Blocking, or
Blocking-Trap.
Web-Based Network Management
normal Ethernet collision-based
129