Advertisement
7. Transport, installation and commissioning
7.1. Transportation
Use lifting equipment such as a crane or forklift to transport the device.
The lifting equipment must be suitable, tested and approved. On flat ground
a sack truck can be used to move the device.
Please note the following instructions during transport:
•
Use suitable tools to secure the device against slipping or tipping over.
•
When transporting the device, only place loads on suitable points.
•
Remove the transport devices after transport.
7.2. Installation and commissioning
To avoid damage to the device or injury to persons, please observe
The following notes apply during installation and commissioning:
•
Installation and commissioning may only be carried out by trained specialists from a
recognized specialist trade company in the SHK sector, taking the necessary safety
measures into account.
•
Before starting the installation, check the device for completeness and possible
transport damage. The following components are included in the delivery: - Device as
ordered, pre-assembled - Operating instructions
•
Place the device on a firm and level surface.
•
Do not install the device in areas subject to frost.
•
Lay cables, hoses and lines so that they do not pose a tripping hazard. Mark
unavoidable tripping hazards.
•
Please install a shut-off device between the main return of the heating system and
the inlet of the Sideflow Clean Pro as well as between the outlet of the Sideflow
Clean Pro and the main return of the heating system. These shut-off devices enable
the control of water supply and drainage during maintenance and repair work.
•
Connect the device to the power supply correctly, observing the electrical
connection data (see section
44
We reserve the right to change the design and technical specifications of our products.
"9 Technical data" on page
48).
Advertisement
Need help?
Do you have a question about the Sideflow Clean Pro and is the answer not in the manual?
Questions and answers