Sideflow Clean Pro Operation - flamco Sideflow Clean Pro Operating Instructions Manual

4. Sideflow Clean Pro Operation

In the following section you will find instructions on how to operate the device.
Preparing the device for operation
A NOTICE
Controls
The controls referred to in the text are described in section
description" from page 14
A NOTICE
When connecting, observe the electrical connection data (see section
"9 Technical data'' on page
Connecting and operating the device
CAUTION
Risk of injury due to improper connection
Improper connection may result in hot liquids leaking or damage to the
device.
• Make connections to the heating system in a depressurized state. To do this, close
the corresponding valves on the heating system.
• Choose the connection points in the heating system's piping system so that they are
far enough apart to avoid a short circuit.
• Install a connection piece of size 1 1/2" at each connection point in the heating
system's pipe system.
The current status of the system is shown below the continuous operation display.
- Select operating mode
- Normal operation active
- Normal operation pause, wait for time slot
- Continuous operation active, change to normal operation after the time has elapsed
• If the pump is active, the pump is displayed in green; if the pump is inactive, the
symbol is black.
• The currently set pump performance is displayed above the pump.
• The current flow rate in l/min is displayed below the pump.
• The color of the filter symbol changes depending on the filter load.
> Sideflow Clean Pro Operation
explained.
48).
Sideflow Clean Pro
"3 Device
17