Ring Tone - Canon MultiPASS F50 Software User's Manual

❏ Speed
Click the transmission speed used to receive faxes. The higher the
setting, the faster the fax is received. If you experience problems
when receiving faxes, try a lower speed setting.
❏ Error Correction (ECM)
Click to reduce system and line errors when receiving a fax. With this
option selected, the system checks each incoming fax for lost data. If
data has been lost from a portion of a page, the system receives that
portion again after confirming that all data within that portion can be
received successfully.
❏ Listen Time Before Ringing
When a call is received, the printer checks to see if the call is from a
fax machine or a telephone. If the printer does not have enough time
to detect the fax tone, it assumes the call is from a telephone. Click to
set the appropriate amount of time to allow the printer to check for
the type of call.
❏ Ring Time
When your printer is set to receive both fax and telephone calls, it
rings to inform you of an incoming telephone call. If you do not pick
up the telephone receiver within a certain amount of time, the printer
stops ringing. Click to set the appropriate amount of time the printer
should ring.
❏ Ring Tone
Click to set the volume level of the ring tone.
❏ Default Action If No Answer to Telephone
Click Receive if you want the printer to handle an incoming call,
detected as a telephone call that is not answered, as an incoming fax.
If no fax is received, the line is then disconnected. If you set this
option to Disconnect, the printer automatically disconnects the
unanswered call, without switching to try and receive a fax.
❏ Manual/Auto Switch
To prevent missing incoming documents when the printer is set to
manual receiving, click to set the unit to automatically answer the
phone and switch to automatic. The unit can receive the incoming fax
after the specified ring time (the number of seconds you specify).
126 Fine-tuning the MultiPASS Suite Chapter 7