Canon MultiPASS F50 Software User's Manual page 13

If the MultiPASS Suite has been copied on a local or network drive, you
can install the software on your system from that drive, rather than using
the installation disk.
To install the MultiPASS Suite (USB port connection):
1. Turn on the printer, but do not connect the printer to your PC until
prompted, or the PC may attempt to install the software before the
unit is ready.
If a New Hardware Found, Update Device Driver Wizard, or Add
New Hardware Wizard dialog box appears, click Cancel.
2. With your PC on, close any open applications (including any virus
checkers).
3. Insert the installation disk into your disk drive.
If you are installing with a copy of the MultiPASS Suite located on
another drive, skip to the next step.
4. If AutoRun is enabled, the installation starts automatically.
If installation does not start automatically, or you are installing from
the software copied on another drive, do the following:
On the Windows taskbar, click Start, and then click Run. In the Run
dialog box, type the following command and click OK (where D: is
the drive containing the installation disk or copied software):
5. When the main menu appears, click Install MultiPASS Suite.
Chapter 2
D:\csplash.exe
Installing and Getting Started 7