Placing Documents; Placing Documents On The Platen Glass; Loading Document In The Feeder - Canon Color imageCLASS MF8050Cn Basic Operation Manual

Placing Documents

Placing Documents on the Platen Glass

1
Open the feeder.
2
Place a document face down.
3
Align the document with the appropriate paper
size marks.
If your document does not match any of the paper size marks,
align the center of your document with the arrow mark.
4
Close the feeder gently.
The machine is ready to scan the document.
When scanning is complete, remove the document from the
platen glass.
2-4
This section describes placing the documents
on the platen glass or load them in the feeder.
CAUTION
Precautions when closing the feeder
• Be careful not to get your fingers caught. This may cause
personal injury.
• Do not press down the feeder forcefully. This may damage the
platen glass and cause personal injury.

Loading Document in the Feeder

1
Spread the original guides a little wider than the
actual document width.
2
Pull out the tray extension before loading the
large size document.
Pull out the tray extension when the document is hanging out of
the document feeder tray.
3
Fan the document stack and even the edges.
Thoroughly fan in
small batches.
Tap the edges on a flat
surface a few times.