Tektronix Z-Active Series User Manual page 24

Figure 7: Connecting the probe for probe calibration (for TDS6000B/C)
5. In the menu bar, select Vertical and select Probe Cal.
Basic operations
A probe calibration routine runs to optimize the probe to the
oscilloscope for both probe attenuation settings.
7. If the probe calibration is successfully completed, the screen will
display Pass.
Tip- Clip ejector
Tip-The Clip ejector is shipped attached to the probe tip and-Used
to remove the Clip assembly.
Notice : Tip-To prevent the Clip housing from wearing out, use the
Tip-Tip from the probe tip using the Clip ejector-We recommend
removing the Clip assembly.
Tip- Clip assembly removal
Follow these steps and Tip-Tip using the Clip ejector-Remove the
Clip assembly.
1. Tip-Clip Grasp the sides of the ejector and insert the Tip in front
6. When the Probe Cal dialog box appears, select Clear Probe Cal,
Z-Active Differential Probe Family User Manual 11
then Calibrate Probe. Select.