Tektronix Z-Active Series User Manual page 29

Notice :To prevent damage to the Tip-Clip or the circuit under test,
be careful not to apply excessive heat with the soldering iron. Use a
low-power,
appropriately sized soldering iron tip.
4. Tip-Solder the leads of the clip to the test points on the circuit
board. See "Tips".
tips
④ To ensure optimal performance and signal integrity, connect the
DUT (device under test) and Tip if possible.-Keep the lead length
between Clip resistors less than 0.050 inch and align the leads to the
④ The loading of the Tip-Clip is relatively low, around 0,1 pF, so
depending on the sensitivity of the circuit to loading, it is
possible to have multiple Tip-Clip assemblies in the circuit while
making measurements. It may be possible to leave it on. of the
circuit to be tested
Tip-Clip loading is lowest when the probe is attached to the
Tip-Clip.
16 Z-Active Differential Probe Family User Manual
TekConnect probes can be connected to some non-TekConnect
equipment using special probe adapters. The 80A03 TekConnect
probe interface is compatible with all TekConnect probes connected
to TDS8X00 and CSA8X00 series oscilloscopes. The RTPA2A
TekConnect probe interface is compatible with all TekConnect probes
connected to RTSA real-time spectrum analyzers. See page 40 for
alternative configurations. .
temperature-controlled
same length.
soldering iron and an
Basic operations