Pre-Scanning An Image - Brother DCP-9040CN Software User's Manual
Brother dcp-9040cn: users manual
Hide thumbs
Also See for DCP-9040CN:
- Service manual (450 pages) ,
- User manual (167 pages) ,
- Network user's manual (103 pages)
Table of Contents
Advertisement
Pre-Scanning an image
The PreScan button is used to preview and also lets you crop any unwanted areas from the image. When
you are satisfied you are scanning the correct area, click the Start button in the Scanner Setup dialog box to
scan the image.
a
Load your document.
b
Click PreScan.
The whole image is scanned into your Macintosh
c
Drag the mouse pointer over the portion you want to scan.
d
Put the document in the ADF again.
Note
If you put the document on the scanner glass in a, skip this step.
e
Adjust the settings for Resolution, Scan Type, Brightness and Contrast in the Scanner Setup dialog
box as needed.
f
Click Start.
This time only the chosen area of the document appears in the application window.
g
You can refine the image in your editing software.
®
and appears in the Scanning Area.
Scanning
9
9
161
Advertisement
Table of Contents
