Scanning An Image Into Your Macintosh; Pre-Scanning An Image - Brother DCP-9010CN User Manual

Scanning

Scanning an image into your Macintosh

You can scan a whole page, or scan a portion after pre-scanning the document.
Scanning a whole page
a
Load your document.
b
Adjust the following settings, if needed, in the Scanner Setup dialog box:
 Resolution
 Scan Type
 Document Size
 Brightness
 Contrast
c
Click Start.
When scanning has finished, the image appears in your graphics application.

Pre-Scanning an image

The PreScan button is used to preview and also lets you crop any unwanted areas from the image. When
you are satisfied you are scanning the correct area, click the Start button in the Scanner Setup dialog box to
scan the image.
a
Load your document.
b
Click PreScan.
The whole image is scanned into your Macintosh and appears in the Scanning Area.
c
Drag the mouse pointer over the portion you want to scan.
d
Put the document in the ADF again.
Note
If you put the document on the scanner glass in step a, skip this step.
8
8
8
8
155