Before Using Network Scanning; Configuring Network Scanning - Brother DCP-9040CN Software User's Manual

Network Scanning
11
If you want to scan from the machine on a network, you must choose the networked machine in the
Device Selector application located in Macintosh HD/Library/Printers/Brother/Utilities/DeviceSelector or
from the Model pop-up menu in the main screen of ControlCenter2. If you already installed the MFL-Pro Suite
Software following the network installation steps in the Quick Setup Guide then this selection should already
be made.
To use the machine as a network scanner, the machine must be configured with a TCP/IP address. You can
set or change the address settings from the control panel. (See Control Panel Setup in the Network User's
Guide.)
Note
For network scanning, maximum 25 clients can be connected to one machine on a network. For example,
if 30 clients try to connect at a time, 5 clients will not be shown on the LCD.

Before using Network Scanning

Configuring network scanning

a
From Library, choose Printers, Brother, Utilities and DeviceSelector, and then double-click
Device Selector.
The Device Selector window appears. This window can also be opened from ControlCenter2.
For more information, see Using ControlCenter2 on page 177.
b
Specify your machine by IP address or mDNS service Name. To change the IP address, enter the new
IP address. You can also choose a machine from the list of the available machines. Click Browse to
show the list.
c
Click OK.
11
11
11
11
193