Define Channel Order; Ws1 / Ws1000 Settings - Elsner WS1 Color Manual

Measured values
Settings

6.1.10.Define channel order

This is where you define the order in which the drives and devices are shown in the
menues. Press the buttons:
Installation
System
Here all configured drives and devices ("channels") are displayed. Note that the list
also includes those channels that do not appear in the manual menu. The display in the
manual menu can be activated or de-activated in the base settings for every single
channel.
 6.1. Set up drives and drive groups
Press the button of the channels to be changed and shift them with the arrow keys that
appear on the right.
Confirm the new sequence with the OK button.

6.2. WS1 / WS1000 Settings

In the menu area System > WS1 / WS1000 Settings you can adjust the following
settings:
• Change personal data such as time/date and location and adjust the screen
display to your personal preferences (Settings)
• Restart, reset to factory defaults and change internal settings of the control
(Service)
• Set an access code to protect the "Installation" and "Automatic Settings"
menus from unauthorised changes
• Storing the set-up data for the control system on the SD card or reading the
data from the SD card (only WS1000 Color)
Control System WS1 Color / WS1000 Color • Version: 29.07.2024 • Technical changes and errors excepted.
97
Display of the current values.
Press the button Adjust to adjust the sensor. Adjust the
value at "displayed temperature/humidity". A correction
to the values measured may be necessary if the temper-
ature/humidity on the sensor does not match the aver-
age for the room (e.g. if the WS1 Color is installed at a
site that is warmer than average). Confirm your selec-
tion using OK.
Press the Manual Menu button in order to set whether
the drive/sensor shall be displayed in the manual menu
or not. Confirm your selection using OK.
Channel Order
Basic Setting