Wireless Connections - Elsner WS1 Color Manual

You can now select individual inputs from the List and adjust their settings. So long as
no settings were completed yet, the buttons show (MF Input 1), (MF Input 2) etc. If
an output was already configured, the function and/or name will be displayed instead.
Press the button of the input to be set. For each multifunctional input the following set-
tings can be changed:
Input type
Reserve
Press the Reserve button. The possible input types appear (motion detector, smoke
detector, climate detector, closed detector, automatic reset, binary input). Select as ap-
propriate. If a multifunctional input is not being used for the moment, leave "Reserve".
Confirm your selection with the OK button.
Name
Name 1
Press the button to change the name. Enter the desired name via the keypad that ap-
pears.
 2.4. Input keyboard for names and codes
Confirm your input with the OK button.
Status of input
It displays whether the relay is currently open or closed.

6.1.6. Wireless connections

Devices that communicate wirelessly with the control unit must first be learned by the
control unit.
When learning wireless connections, always comply with the data sheet of the relevant
wireless device. The instructions for learning WGTH-UP indoor sensors can be found
in the Chapter Setting up a wireless connection using WGTH-UP.
WARNING!
Electric voltage!
Some devices have programming keys for learning the radio connection
inside their housings. and thus beneath unprotected live parts.
•This devices should only be learned by a trained electrician
(according to VDE).
Control System WS1 Color / WS1000 Color • Version: 29.07.2024 • Technical changes and errors excepted.
88 Basic Setting