Indoor Sensor For Weather Display; Setting Camera Inputs - Elsner WS1 Color Manual

6.1.7. Indoor sensor for weather display

In the weather data display, the values from a sensor (e.g. internal sensor of WS1 Color
or wireless sensor WGTH-UP) can be displays. Wireless sensors have to be taught in
to the control first.
Select the desired sensor here. Press the buttons:
Installation
System
Sensor Selection
Press the button to reach the selection menu with the sensors. Then press the button
of the desired sensor and confirm using the OK button.

6.1.8. Setting Camera Inputs

This menu point only appears if the control is equipped with a camera inter-
face!
In order to set up camera interface and inputs, press the buttons:
Installation
System
Camera 1/2
If you want to set both camera inputs, press the button with the name of the camera.
In the pre-settings, the cameras are called "Camera 1" and "Camera 2". You can change
the names in this menu.
You can perform the following settings on each camera:
Test pattern
Using the camera
Name
Control System WS1 Color / WS1000 Color • Version: 29.07.2024 • Technical changes and errors excepted.
95
Weather Display
Camera
Press Show Picture, in order to show the current cam-
era picture. If no camera is connected, nothing will be
displayed.
Confirm your entry by pressing OK.
Press the button in order to activate or deactivate this
camera. Select Yes or No.
Confirm your entry by pressing OK.
Press the button with the device's designation (pre set-
ting: camera 1/2), in order to change the name. Enter
the desired name using the key pad that appears. Con-
firm your selection using OK.
 2.4. Input keyboard for names and codes
Basic Setting