Elsner WS1 Color Manual page 45

Press Select to select the time periods. Activate one or more periods on the list. The
periods can be individually customised (see below).
Confirm your setting by pressing OK.
To change any of the time periods, press Timer.
 3.3. Set timer
Movement Limitation
Press the button to activate or deactivate the movement range limitation for this
window at low outdoor temperatures.
The conditions for the triggering of the movement limitation (outdoor temperature, pe-
riod) are defined in the "General Settings" menu.
 System > Automatic Setttings > General Settings > Movement Limitation
 3.3. Set movement limitations (windows)
Confirm your setting by pressing OK.
to Position
Press the button to set the movement position when movement limitation is active.
The button will only be activated once the movement limitation has been activated.
Input the maximum movement position in % using the arrow buttons (0% = closed,
100% = fully open). Default: 50%.
The window can be reopened fully by hand.
Confirm your setting using the OK button.
Confirm your setting by pressing OK.
Outdoor Temp.
Press the button to set the outdoor temperature block. The effect of the block is that the
window remains in the current position. The outdoor temperature block can, for exam-
ple, be used if the window should not be used for ventilation in winter (cold protection
for plants).
The outdoor temperature block only applies for automatic operation; no ventilation
then takes place. When the rain or wind alarm is triggered, the window will be closed
despite the outdoor temperature block (the alarm has priority over temperature block).
Manual operation continues to remain possible, even when the window is blocked be-
cause of low outdoor temperatures.
Set value: Use the arrow buttons to change the value according to your wish. Default
setting: 5.0°C
Control System WS1 Color / WS1000 Color • Version: 29.07.2024 • Technical changes and errors excepted.
43 Automatic settings