Configuring Internal Thermometer/Hygrometer Of Ws1 - Elsner WS1 Color Manual

Camera off after ... (sec.)
Multif. Input
Interface
Press the button if you want to de-activate the camera interface. This is only necessary
if the interface fails or is removed when the control system is running and an error
message is displayed ("Camera interface defect"). By de-activating the interface the er-
ror message is suppressed and the weather animation will be displayed normally
again.
De-activating: If the camera interface is to be turned off, select Yes.
Confirm your setting by pressing OK.
6.1.9. Configuring internal thermometer/
hygrometer of WS1
To configure the internal sensor of WS1, press the buttons:
Installation
System
Sensor type
Name
Status
Control System WS1 Color / WS1000 Color • Version: 29.07.2024 • Technical changes and errors excepted.
96
Press the button with the numeric value in order to set
how long the camera's picture shall be displayed on the
weather data screen. After the pre-set time has expired,
the picture fades out. Enter the desired time (seconds)
using the keypad that appears.
Confirm your entry by pressing OK.
Press the button Assign, in order to assign the camera
to a multifunction-input. The camera then comes on
automatically as soon as signal is picked up at this
input (e. g. motion detector). Several inputs can also be
selected. Confirm your entry by pressing OK.
WS1 TH
Display "WS1 TH"
Press the button with the device's designation (pre set-
ting: Thermo/hygro), in order to change the name.
Enter the desired name using the key pad that appears.
Confirm your selection using OK.
 2.4. Input keyboard for names and codes
Display of status
Basic Setting