Factory Settings; Internal Area; Access Code - Elsner WS1 Color Manual

Reset
Press Reset and the control system restarts.

Factory settings

ATTENTION
Material damage due to inappropriate use of the service
functions!
In normal operation of the control unit, the service settings are not used.
By resetting to the factory defaults all basic and automatic settings will be deleted. The
control unit will once again be in the condition it was when delivered.
The Factory settings can be accessed by pressing the buttons:
WS1 / WS1000
Settings
System
Factory Defaults
Select Factory Defaults. Enter the code "81" via the keypad which appears and con-
firm with the OK button. The factory settings will be loaded and the control system re-
started.

Internal area

In the internal area, basic data of the device can be modified. You are not authorised
to change this.

6.2.3. Access code

In the System > WS1 / WS1000 Settings > Access code menu area you can set
an access code which locks the "Installation" and "Automatic Settings" menus against
unauthorised changes. Manual operation of the control system remains possible at
any time.
The access code settings can be accessed by pressing the buttons:
WS1 / WS1000
Settings
System
Here you can enter, change and delete a code.
Control System WS1 Color / WS1000 Color • Version: 29.07.2024 • Technical changes and errors excepted.
102
Service
Access Code
Basic Setting