NAC Image Technology MEMRECAM Q5 User Manual page 57

When the Q5 is connected to HXLink after setting the IP address, the following error

message may appear. In this case, the IP address setting may be incorrect so please check
and reset if necessary.
When setting the IP address, the following error message may appear and it may not be

possible to set the camera. Turn the camera power ON and confirm the settings again.
It is necessary to change the IP address of the control PC to the connectable setting in the

IP address after the Q5 change beforehand. The modifiable IP address of Q5 depends on the
setting of the IP address of the PC.
(00419)D
3-5
Setting the IP Address