Aeronaut Shorty Building Instructions page 4

4
Glue wing sheeting panels 10 and 11 together on a flat surface (protect
with cling film!). Remove excess glue immediately and secure joint with
tape.
Weigh down sheeting panels until glue has set.
10
11
6
Carefully remove wing panel from building jig and turn upside
down. Remove rib jig H2 from ribs and carefully cut off tabs
from ribs with modeller's knife or razor saw.
Carefully sand underside of ribs to remove remaining holding
tabs .
5
Place wing sheeting on recessed portion of nose profile and
match tabs of tip rib 7 with corresponding notches.
Glue sheeting panel in place. Secure with tape and pins to
profile and ribs, respectively.