Page 1
Outboard Hydroplane RX-3 Order no. 3043/00...
Page 2
Water-cooling system for the electric motor Ÿ Speed controller Ÿ Steering servo Ÿ The following components are required before the RX-3 can be run on the water: Radio control system and receiver Ÿ 3S LiPo drive battery Ÿ Specification - model Specification - speed controller...
Operating instructions Please bear in mind that incorrect usage may involve a risk of injury, and could cause damage to other components. Please study these operating instructions carefully before operating the boat for the first time. Important notes Read right through these instructions before running the boat. Ÿ...
Programming the speed controller using the RC system This is the procedure for programming the controller: Locate the receiver lead attached to the controller, and connect it to the receiver socket for the throttle channel. Ÿ Move the motor control lever to the maximum (full-speed) position, then switch the transmitter on. Ÿ...
Page 5
Programming the speed controller using a ProgCard (optional accessory) Fit the jumper at the correct position. Ÿ Locate the receiver lead attached to the controller, and connect it to the corresponding socket on the ProgCard Ÿ (orange = signal, brown = (-), red = (+) ). Connect the motor and drive battery to the controller.
Page 6
If a racing boat is to attain as high a speed as possible, combined with safe handling on the water, it is essential to align the power system correctly and set the appropriate Centre of Gravity. Naturally this applies to the RX-3.
Page 7
CG to the point where control is difficult. However, if you observe the points stated here, the RX-3 is safe to operate, and has predictable handling; it will give you many hours of fun at the lakeside.
Page 8
Other models available in our range: Alex 3047/00 Jenny 3055/00 Bellissima 3012/00 Spitfire 3052/00 and you can find even more at www.aero-naut.com aero naut aero-naut Modellbau Stuttgarter Strasse 18-22 D-72766 Reutlingen www.aero-naut.com...
Need help?
Do you have a question about the RX-3 and is the answer not in the manual?
Questions and answers