Table of Contents
Advertisement
7. Leveling the Platform 1
1. To calibrate the printing platform, first
raise the platform, loosen the plastic head
screws on the left and right sides of the
filament tray, and remove the tray.
Note: The printing platform is already leveled at the factory. If you need to re-level it due to transportation or other reasons, please follow the above-mentioned
steps. (The user needs to prepare a piece of flat A4 paper by themselves.)
07
2. loosen the four screws on the connection
plate of the modeling platform board and
press the A4 paper against the printing
screen. Press Settings → Z-axis Movement →
Leveling (refer to the 2-step operation for
leveling the platform) to check whether the
platform fits evenly with the paper.
3. After confirming that the A4 paper fits
evenly, tighten the four screws on the
platform.
Advertisement
Table of Contents
Need help?
Do you have a question about the HALOT-ONE and is the answer not in the manual?
Questions and answers
One of the screws that calibrates the printing platform is stripped and I'm having trouble finding screws of the same width to replace it. What measurements do these screws use exactly?