Preparing A Coffee - Fagor CR-14 - 2008 Manual

the appliance and do not attempt to
repair. If a repair is required, contact a
Technical Assistance Service authorised
by the manufacturer and request the use
of original spare parts.
•
If the cable for this appliance is
damaged, contact an authorised
Technical Assistance Service for it to be
replaced.
• Do not leave the appliance exposed to
the elements (rain, sun, ice, etc.).
• Do not use or let any part of the
appliance come into contact or near hot
surfaces (kitchen gas or electric hobs or
ovens).
•
Do not use detergents or abrasive
sponges to clean the appliance.
•
Do not touch the hot surfaces. Use the
handles.
• Do not let the cable come into contact
with the hot parts of the appliance.
• Never use the appliance with no water in
the tank.
• Do not heat inflammable liquids with the
steam.
• The drip tray and mesh must be correctly
fitted before operating the coffee maker.
•
Warning! The steam outlet and the filter
holder heat up when the coffee maker is
working and there is a risk of scalding.
• When the coffee maker is working under
pressure there is a risk of scalding. When
preparing coffee, the filter holder must be
correctly fitted.
•
Do not remove the filter holder when the
appliance is working.
•
When the appliance is working the water
in the tank must always be above the
MIN level.
4. BEFORE USING FOR THE FIRST TIME
Before using the coffee machine for the
first time wash the filters (15 and 16), the
measuring scoop (12), the water tank (13)
and the steam outlet (9) with soapy water.
Rinse all the components well.
The inside of the coffee machine must also
be cleaned. To do so fill the tank (13) with
water and operate the machine without
coffee several times one after the other.
5. STARTING UP
1. Open the tank cover (1) and remove the
tank (13). Fill the tank (13) with clean fresh
water up to the MAX mark, and insert into
the coffee machine again.
2. Plug the coffee machine into the electrical
supply and push the start/stop button (8).
The pilot light (4) will start to flash.
3. When connecting the coffee machine for
the first time, it should be preheated. To
do so push the button for 1 and 2 cups (6
and 7) at the same time for 3 seconds. The
coffee machine will start to heat up and
the pilot light (4) will flash until a suitable
temperature for making coffee is reached.
4. When the pilot light remains constant, the
coffee machine will have reached a suitable
temperature and will be ready to make
coffee.
6. PREPARING A COFFEE
• Once the coffee maker has been started
up, select a filter (15 or 16), place it in the
filter holder (14) and fill it depending on the
amount of coffee you wish to make.
- One cup of coffee: Fill the filter for 1
cup (15) with a scoopful of ground
coffee (7g).
- Two cups of coffee: Fill the filter for
2 cups (16) with two scoopfuls of
ground coffee (14g).
We recommend you use the scoop (12)
provided as a measurement for a cup (7g)
Press the coffee into the filter with the rear
part of the scoop (12) and ensure that any
loose coffee remaining on the outer edge of
the filter holder is removed.
• Insert the filter holder into the machine (14)
at the crown and turn it firmly from left to
right (fig. B).
• Place one or two cups on the drip tray (11),
under the filter holder (14) coffee spouts
• Push the button for 1 cup (6), if one cup
of coffee is required (50cc); or the two-cup
button (7) if we want to make two cups of
coffee (100cc).
• The coffee will start to be dispensed
and will stop when the amount of coffee
10