Before Using For The First Time; Making Coffee - Fagor ETNA Series Instructions For Use Manual

1. DESCRIPTION OF THE
PRODUCT (FIG. 1)
1. Upper body.
2. Filter.
3. Rubber gasket.
4. Funnel.
5. Base.
6. Valve.
2. INSTRUCTIONS FOR USE
These coffee makers can be used in
conjunction with any heat source, with
the following exceptions:
The 3-cup coffee maker is not suitable
for induction hobs due to its reduced
diameter. The 6- and 10-cup coffee
makers are suitable, although you may
experience problems with some hob
models depending on the adjustment of
the detector.
These coffee makers cannot be used in
conjunction with any type of oven.
3. BEFORE USING
FOR THE FIRST TIME
Before using your coffee maker for the
first time, dismantle it and clean all the
elements with water and bicarbonate.
See the section on cleaning.
We recommend that you carry out a few
test runs before making your first cup of
real coffee, in order to enable the
different elements to become
impregnated with the aroma.

4. MAKING COFFEE

a) Fill the base of the coffee maker with
water (do not exceed the level of the
valve, Fig. 2).
b) Insert the funnel into the base (Fig. 3)
and fill with coffee (Fig. 5). The reducer
can be placed as shown in Figure 4 if
you wish to use less coffee.
GB
c) Screw the upper body onto the base
(Fig. 6) and place the coffee maker over
the heat.
When the coffee has filtered through to the
upper body, remove the coffee maker from
the heat.
5. CLEANING
We recommend that you wash the coffee
maker after every use with warm water
and washing up liquid.
The bottom part of the coffee maker and
the funnel can be washed in the
dishwasher. Do not use abrasive
detergents, wire brushes or bleach to
clean the coffee maker.
6. REPLACEMENT PARTS (Fig. 6)
The rubber seal that the coffee maker has
in the base of the top part must be
replaced when steam starts to escape
around it. Always use original replacement
parts.
When requesting replacement parts,
always state the type and capacity of your
coffee maker.
Coffee
maker
4T
6T
10T
5
Replacement parts
3 rubber gaskets
+ 1 filter
CI-04 ETNA
CI-06 ETNA
CI-10 ETNA