Fault Messages In The Display - Miele W 4449 WPS LIQUIDWASH Operating Instructions Manual

Problem solving guide

Fault messages in the display

Problem
q
Fault
Check drainage
system
p
Fault
Water intake
Open stopcock
o
Waterproof system
activated
Close the stopcock
,
Technical fault.
Call the Service
Department
The following flashes in
the display:
Anti-crease
alternately with
Check detergent
A To switch off the fault message: Switch the machine off with the I-On/0-Off
button.
46
Possible cause
– The water outlet is
blocked or
restricted.
– The drain hose has
been fixed too high.
The water inlet is
blocked or restricted.
The water protection
system has reacted.
There is a fault.
Excessive foam has
built up during
washing.
Remedy A
– Clean the drain filter and
the drain pump.
– The maximum delivery
head is 1 m.
Check whether
– the stopcock is opened
properly.
– the inlet hose is kinked.
Call the Service
Department.
Start the programme again.
If the fault message
appears again, contact the
Service Department.
Check:
– the amount of detergent
used.
– the dosage level, if using
Automatic dispensing.
Follow the instructions on
the manufacturer's
packaging and also take
the degree of soiling of the
laundry into account.