Speaker Setup - Onkyo TX-NR3010 Instruction Manual

Speaker Setup

1 2 3 4
"Setup"
Main Menu Speaker Setup
Some of the settings in this section are set automatically
by Audyssey MultEQ ® XT32 Room Correction and
Speaker Setup function (➔ page 42). For Speakers B,
you need to change the settings manually.
Here you can check the settings made by
Audyssey MultEQ XT32 Room Correction and Speaker
Setup function, or set them manually, which is useful if
you change one of the connected speakers after using
Audyssey MultEQ XT32 Room Correction and Speaker
Setup function.
Press RECEIVER and use SP on the remote controller to
select Speakers A or Speakers B. For details on SP, see
"Selecting Speaker Layout" (➔ page
Note
• These settings are not available in either of the following cases:
– a pair of headphones is connected.
– the "Audio TV Out" setting is set to "On"
– "HDMI Control(RIHD)" is set to "On"
you're listening through your TV speakers.
Speaker Settings
5
If you change these settings, you must run
Audyssey MultEQ XT32 Room Correction and
Speaker Setup again
If the impedance of any speaker is 4 ohms or more but less
than 6, set the minimum speaker impedance to 4 ohms.
If you bi-amp the front speakers, you must change the
"Speakers Type(Front A)" or "Speakers
Type(Front B)" setting. For details on speaker wire
connection, see "Bi-amping the Front Speakers"
(➔ page 18). When connecting speakers without
crossover network, you need to change the "Speakers
Type(Front A)" or "Speakers Type(Front B)" setting
beforehand. For details on connection, refer to "Using
Speakers Without Crossover Network"
Note
• When bi-amping is used, the AV receiver is able to drive up to 7.2
speakers in the main room.
55).
• Before you change these settings, turn down the volume.
■
Speaker Impedance
4ohms:
Select if the impedance of any speaker is 4 ohms or
(➔ page 84).
more but less than 6.
(➔ page 83) and
6ohms:
Select if the impedances of all speakers are between 6
and 16 ohms.
■
Speakers Type(Front A)
Normal:
Select this if you've connected your front speakers A
normally.
Bi-Amp:
Select this if you've bi-amped your front speakers A.
Digital Crossover:
Select this if you're using speakers without crossover
network.
(➔ page 42).
(➔ page 18).
En-66
Advanced Operations
■
Speakers Type(Front B)
No:
Select this if you're not using speakers B.
Normal:
Select this if you've connected your front speakers B
normally.
Bi-Amp:
Select this if you've bi-amped your front speakers B.
Digital Crossover:
Select this if you're using speakers without crossover
network.
Tip
• If "Speakers Type(Front A)" or "Speakers Type(Front B)" is
set to "Digital Crossover", a confirmation screen appears. Select
"Next (2-7. Digital Processing Crossover Network)" to display
the screen for Digital Processing Crossover Network
(➔ page 71). Continue with the settings.
■
Powered Zone 2, Powered Zone 3
No
Yes:
Zone 2/3 speakers can be used. (Powered Zone 2/3
enabled).
■
11ch Playback
No
Yes
For 11.2-channel playback, set this setting to "Yes". If you
select front wide speakers setting in Speaker Configuration
is set to "None", it will be automatically switched to
"80Hz (THX)".
To be continued