Speaker Setup - Onkyo TX-NR636 Advanced Manual

2.Speaker Setup

Allows you to change the speaker configuration such as existence of subwoofer, crossover
frequency, and so on. Settings are automatically configured if you use the Automatic
Speaker Setup.
Furthermore, you will not be able to select this setting if you have a pair of headphones
connected or you are listening through your TV speakers.
Speaker Settings
Change the impedance of the connected speakers, the type of front speaker connection,
and other speaker settings.
Setting item Default Value
Speaker 6ohms
Impedance
(European,
Australian and
Asian models)
Front Speakers Normal
Type
Powered Zone 2 No
• For impedance, check the indications on the back of the speakers or their instruction manual.
24
Setting Details
Set the impedance of the connected speakers.
"4ohms": When any of the connected speakers
have 4 Ω or more to less than 6 Ω impedance
"6ohms": When the connected speakers all have 6
Ω or more impedance
Select the type of front speaker connection.
"Normal": When front speakers are connected in a
normal manner
"Bi-Amp": When front speakers are bi-amp
connected
Set presence of speaker terminal connection of
Zone 2
"Yes": When speakers are connected to ZONE2
speaker terminals
"No": When speakers are not connected to ZONE2
speaker terminals
• If "Front Speakers Type" is set to "Bi-Amp", this
setting will be set to "No".
Speaker Configuration
Allows you to change the speaker configuration such as presence or not of each speaker,
crossover frequency, and so on. Settings are automatically configured if you use the
Automatic Speaker Setup. Audio will not be output while you are making this setting.
Setting item Default Value
Subwoofer Yes
Front 100Hz
Center 100
Hz
Surround 100
Hz
Advanced Settings
Setting Details
Set whether a subwoofer is connected or not.
"Yes": When subwoofer is connected
"No": When subwoofer is not connected
Select the frequency to start outputting bass
frequencies (crossover frequency) for each
channel from "40Hz" to "200Hz".
"Full Band": Full band will be output.
"None": When no compatible speaker is connected
• "Front" will be fixed to "Full Band" if "Subwoofer"
is set to "No", and the bass frequencies of the
other channels will be output from the front
speakers. To make the settings, refer to the
instruction manual of the speakers used.
Select the frequency to start outputting bass
frequencies (crossover frequency) for each
channel from "40Hz" to "200Hz".
"Full Band": Full band will be output.
"None": When no compatible speaker is connected
• This setting cannot be set to "Full Band" unless
"Front" is set to "Full Band".
Select the frequency to start outputting bass
frequencies (crossover frequency) for each
channel from "40Hz" to "200Hz".
"Full Band": Full band will be output.
"None": When no compatible speaker is connected
• This setting cannot be set to "Full Band" unless
"Front" is set to "Full Band".