Controlling Multi Zone Components - Onkyo TX-NR3010 Instruction Manual

Controlling Multi Zone Components

■
Operating on the AV receiver
Input selector buttons
MASTER VOLUME
ZONE 3
ZONE 2 OFF
Tip
• The Whole House Mode function shares the input source of main
room with Multi Zone (➔ page 55).
1 To turn on Zone 2/3 and select an input source,
press ZONE 2 or ZONE 3 followed by an input
selector button within 8 seconds.
Zone 2/3 turns on, the Z2 or Z3 indicator lights on the
AV receiver's display.
Tip
• The corresponding trigger output goes high (+12 V).
To select AM or FM, press ZONE 2 or ZONE 3 and
the TUNER input selector repeatedly.
To select the same source as the main room's, press
ZONE 2 or ZONE 3 twice. "Zone 2 Selector:
Source" or "Zone 3 Selector: Source" appears on the
AV receiver's display.
2
To turn off Zone 2/3, press ZONE 2 or ZONE 3.
The Z2/Z3 indicator on the AV receiver's display
flashes. Press OFF.
The zone is turned off.
Tip
• The corresponding trigger output goes low (0 volts).
■
Operating on the remote controller
To control Zone 2/3, you must press ZONE on the remote
controller first.
ZONE turns red when Zone 2 is on, and green when
Zone 3 is on.
8RECEIVER
ZONE
Input selector buttons
MUTING
VOLq/w
1 Press ZONE repeatedly, then point the remote
controller at the AV receiver and press
8RECEIVER.
Zone 2/3 turns on, the Z2 or Z3 indicator lights on the
AV receiver's display.
Tip
• The corresponding trigger output goes high (+12 V).
2
To select an input source for Zone 2/3, press ZONE
repeatedly, followed by an INPUT SELECTOR
button.
To select AM or FM, press ZONE and the TUNER
input selector repeatedly.
En-89
Advanced Operations
3
To turn off Zone 2/3, press ZONE repeatedly,
followed by 8RECEIVER.
The zone is turned off.
Tip
• The corresponding trigger output goes low (0 volts).
Adjusting the Volume for Zones
■
Operating on the remote controller
1 Press ZONE repeatedly.
2
Use VOL q/w.
■
Operating on the AV receiver
1 Press ZONE 2 or ZONE 3 (the Z2/Z3 indicator on
the AV receiver's display flashes).
2 Use MASTER VOLUME control within 8 seconds.
If your Zone 2/3 speakers are connected to a receiver or
integrated amplifier in Zone 2/3, use its volume control to
adjust the volume.