Using The Setup Menu (Home) - Onkyo TX-NR3010 Instruction Manual

Using the Setup Menu (HOME)

ENTER
q/w/e/r
HOME
1 Press RECEIVER followed by HOME.
2
Use e/r to select "Setup", and then press ENTER.
3
Use q/w to select a main menu item, and then press
ENTER.
4
Use q/w to select a sub menu item, and then press
ENTER.
5
Use q/w to select a setting target, and use e/r to
change the setting.
Press HOME to close the menu.
Press RETURN to return to the previous menu.
Note
• This procedure can also be performed on the AV receiver by
using SETUP, the cursor and enter (middle) buttons.
• During Audyssey MultEQ ® XT32 Room Correction and Speaker
Setup, messages, etc., that are displayed on the TV screen will
appear on the AV receiver's display.
■
Screen Saver
If there is no video signal on the current input source and
no operation for a specific time (three minutes by
default), a screen saver automatically comes on.
Tip
RECEIVER
• The time until the screen saver activates itself can be changed
in the "Screen Saver" setting
• The screen will return to its previous state if the AV receiver is
operated.
RETURN
(➔ page 83).
En-61
Advanced Operations
Explanatory Notes
a Main Menu Speaker Setup
b Speaker Configuration
■
Subwoofer
c
d
1ch:
Audio signal is outputted from SW1 jack
only.
2ch:
Audio signal is outputted from SW1 and
SW2 jacks.
a Main Menu
b Sub Menu
c Setting target
d Setting options (default setting underlined)
Sub Menu
Main Menu