Onkyo TX-NR3010 Instruction Manual page 44

9
Use q/w to select an option, and then press ENTER.
MultEQ XT32: Auto Setup
-- Review Speaker Configuration --
Subwoofer 2ch
Front 40Hz
Center 40Hz
Surround 100Hz
Front Wide None
Front High 100Hz
Surround Back 120Hz
Surround Back Ch 2ch
Save
Cancel
The options are:
Save:
Save the calculated settings and exit
Audyssey MultEQ ® XT32 Room Correction and
Speaker Setup.
Cancel:
Cancel Audyssey MultEQ XT32 Room
Correction and Speaker Setup.
Tip
• You can view the calculated settings for the speaker
configuration, speaker distances, and speaker levels by
using e/r.
10
Use q/w to select a target, and use e/r to change
the setting.
After the results of Audyssey MultEQ XT32 have
AUDYSSEY
been saved, the menu will display the "Audyssey"
(➔ page 76), "Dynamic EQ"
"Dynamic Volume"
Note
• When "Audyssey Quick Start" has been used for
measurement, "Audyssey" cannot be selected.
• These settings are applied to all input selectors.
11
Press ENTER.
12 Disconnect the speaker setup microphone.
Note
• You can cancel Audyssey MultEQ XT32 Room Correction and
Speaker Setup at any point in this procedure simply by
disconnecting the setup microphone.
• Do not connect or disconnect any speakers during
Audyssey MultEQ XT32 Room Correction and Speaker Setup.
• If the AV receiver is muted, it will be unmuted automatically
when Audyssey MultEQ XT32 Room Correction and Speaker
Setup starts.
• Changes to the room after Audyssey MultEQ XT32 Room
Correction and Speaker Setup requires you run
Audyssey MultEQ XT32 Room Correction and Speaker Setup
again, as room EQ characteristics may have changed.
(➔ page 76),
(➔ page 76) settings.
En-44
Turning On & Basic Operations
Error Messages
While Audyssey MultEQ XT32 Room Correction and
Speaker Setup is in progress, one of the error messages
below may appear.
MultEQ XT32: Auto Setup
Ambient noise is too high.
Retry
Cancel
Error message
The options are:
Retry:
Try again.
Cancel:
Cancel Audyssey MultEQ XT32 Room Correction
and Speaker Setup.
• Ambient noise is too high.
The background noise is too loud. Remove the source of
the noise and try again.
• Speaker Matching Error!
The number of speakers detected was different from that
of the first measurement. Check the speaker connection.
• Writing Error!
This message appears if saving fails. Try saving again. If
this message appears after 2 or 3 attempts, contact your
Onkyo dealer.
• Speaker Detect Error
This message appears if a speaker is not detected. "No"
means that no speaker was detected.
Tip
• See "Speaker Configuration" for appropriate settings
(➔ page 13).
AUDYSSEY