Download
Share
Print this page
Onkyo PR-SC5507 Firmware Update
  1. Manuals
  2. Brands
  3. Onkyo Manuals
  4. Receiver
  5. PR-SC5507
  6. Firmware update
Onkyo PR-SC5507 Firmware Update

Onkyo PR-SC5507 Firmware Update

Hide thumbs Also See for PR-SC5507:
1
2
3
4
5

Advertisement

Quick Links

Download this manual
Firmware Update for TX-NR1007/3007/5007 and PR-SC5507
There are the following methods to update the firmware: via network and via USB storage. Please choose
either one that suits your condition. Before you start, carefully read the update procedure.
To update the firmware, it will take 15 to 25 minutes for TX-NR1007 and 30 to 40 minutes for
TX-NR3007/5007 and PR-SC5507.
■ Update via network
You need a wired Internet connection to update the firmware.
For the update procedure, please refer to
■ Update via USB storage (excluding TX-NR1007)
Please prepare a USB storage device such as a USB flash memory stick. You need at least 32 MB of available
space to update the firmware.
For the update procedure, please refer to
Precautions on the USB storage device:
• The storage media in the USB card reader may not work.
• If the storage device has been partitioned, each section will be treated as an independent device.
• If the USB mass storage device contains a lot of data, the AV receiver/controller may take a while to read it.
• Operation with all USB mass storage devices including the ability to power them is not guaranteed.
• Onkyo accepts no responsibility whatsoever for the loss or damage to data stored on a USB mass storage device when that device is used
with the AV receiver/controller. We recommend that you back up your important music files beforehand.
• If you connect a USB hard disk drive to the USB port, we recommend that you use its AC adapter to power it.
• USB hubs and USB devices with hub functions are not supported. Do not connect your USB mass storage device via a USB hub.
• USB memory devices with security functions are not supported.
"Updating the Firmware via Network" on page
"Updating the Firmware via USB" on page
2.
4.

Advertisement

loading
Need help?

Need help?

Do you have a question about the PR-SC5507 and is the answer not in the manual?

Questions and answers

Related Manuals for Onkyo PR-SC5507

Summary of Contents for Onkyo PR-SC5507

  • Page 1 • Operation with all USB mass storage devices including the ability to power them is not guaranteed. • Onkyo accepts no responsibility whatsoever for the loss or damage to data stored on a USB mass storage device when that device is used with the AV receiver/controller.

  • Page 2: Updating The Firmware Via Network

    Updating the Firmware via Network TX-NR1007/3007/5007 and PR-SC5507 allow you to Step4: update firmware using Network connection on rear panel. Select “Via NET” and push [ENTER]. In this procedure, on-screen display may vary depending on the model. Note: 1. Make sure your AV receiver/controller and TV are turned on and Ethernet cable is connected to rear panel of the AV receiver/controller.

  • Page 3: Troubleshooting

    *-10, *-20 Ethernet cable is not detected. Connect the Asia, Oceania, Middle East, Africa cable properly. See the instruction manual for Please contact an ONKYO distributor referring to Onkyo the network connection. SUPPORT site. <http://www.intl.onkyo.com/support/local_support/index.html> *-11, *-13, Internet connection error.

  • Page 4: Updating The Firmware Via Usb

    Connect a USB storage device to your PC. If there is any data in the USB storage, remove it. Step2: Download the firmware file from the Onkyo web site. The file name is as follows: ONKAVR0001_*******.zip Extract the zip file that you have downloaded. The...
  • Page 5 You do not need to do anything Please contact an ONKYO distributor referring to Onkyo SUPPORT site. further. <http://www.intl.onkyo.com/support/local_support/index.html> Y0910-2 SN 29400292A (C) Copyright 2009 ONKYO CORPORATION Japan. All rights reserved. * 2 9 4 0 0 2 9 2 A *...

This manual is also suitable for:

Tx-nr1007Tx-nr3007Tx-nr5007