Paper Installation; Paper Loading; Solution To Paper Jam - SPRT SP-POS8811A Manual

2.2 Paper Installation

2.2.1 Paper Loading

Steps of Loading Thermal Paper are as below:
Hold down the upper cover button on the left side, open the movable upper cover, draw a certain length
of the paper roll, put the paper end on the print head, close the upper cover and press it downwards
lightly.
1. Pay attention to the direction of loading paper, make the printing surface face to the print
head.
2. Please don't feed or draw the paper forwards or backwards with hands.
3. Keep clean of the print head, avoid to influence the printing quality.

2.2.2 Solution to Paper Jam

If cutter jam, turn off the power, and turn on again, the cutter will be back to original position. If paper
jam, open the printer paper cover, and take out the paper. If the cutter still does not return to its original
position after turning on the power again, open the cover of it, and turn the white plastic gear by the
direction suggestive on the cutter by hand to make the cutter be back to the original position.
Figure 2-1 The name of each part of the printer
Caution:
6