Replacing The Ribbon - Dascom DST-85 User Manual

Dascom DST-85
 Press the ▼/▲ Key until [ Std card exit]/[Error card exit] is displayed. Press the SET Key.
 Press the ▼/▲ Key to change settings. Press the SET Key.
By factory defaults, the Printer outputs correctly printed cards and rejected ones
to the front and rear slots, respectively. If configured with duplex option, the
rejected cards are ejected out the rear slot by default, while without duplex
option, the rejected cards are ejected out the front slot by default.

2.2 Replacing the Ribbon

Change the ribbon when the OLED Display prompts [RIBBON END] message.
Approved Ribbons for this printer:
Type
YMCKO Ribbon
1/2(YMC)KO Ribbon
K Ribbon
YMCKOK Ribbon
Please contact your local Reseller for ribbons not listed above.
•
•
•
•
•
You can get the unused quantity of ribbon.
Refer Section 3.3 to get the unused amount of your ribbon.
Via the OLED Panel or through the Printers Driver, an estimation of the remaining Ribbon quantity can
Description
Direct touching contaminates the Ribbon and causes uneven print quality.
Avoid excessive impact on the Ribbon when replacing them.
Using non-genuine products may cause poor print quality and Printer
malfunction.
Quality and reliability of the non-genuine products are not guaranteed.
Even within the warranty period, fees may be charged on servicing the
printer using non-genuine products.
Product Code
1
User Guide V1.0