SM980IM_GB
15/03/2005
Problem:
The temperature measurement of
remote sensor and receiver does not
match.
Receiver is no longer receiving
remote sensor signals or display.
16
11:22
Page 16
TROUBLESHOOTING
Solution :
Wait for about 1-2 minute to ensure the remote
sensor and receiver are in phase. Otherwise,
re-synchronize receiver by holding CHN for 3
seconds until a beep is heard.
Repeat the learning procedures.
-
Temperature may be below -30°C.
-
Batteries in remote sensor may need
changing.
-
Move remote sensor closer to the receiver.
-
Make sure remote sensor is away from
sources of electrical disturbance.
Copyright © Lexibook 2005