Remote Unit; Main Unit; Installing And Configuring The Transmitter Or Remote; Transmitter(S) - LEXIBOOK SM1102 Manual

SM1102 English 7/2/04
The remote unit functions on two "AAA" batteries. To insert or replace these batteries,
follow these steps:
1. Remove the stand with the handle.
2. Loosen the screw at the back of the compartment and remove the lid.
3. Insert the alkaline batteries, taking care to follow the polarity indications.
4. Replace the lid on the unit and secure it by tightening the screw firmly.
5. If the "battery low" indicator flashes on the LCD, you must replace the batteries.
6. The unit is now ready to receive the telecode and house code. (Please refer to the
section on CONFIGURING THE TRANSMITTER OR REMOTE TRANSMITTERS).
IF THE TEMPERATURE FALLS BELOW -18°C (0°F), THE BATTERY IN THE
REMOTE UNIT IS LIABLE TO FREEZE. IN THESE CONDITIONS, IT IS
RECOMMENDED THAT YOU BRING THE REMOTE UNIT INDOORS. THE BATTERY
MANUFACTURER SHOULD BE ABLE TO TELL YOU THE FREEZING POINT OF THE
BATTERY.
The main unit functions on two "AA" batteries. To insert or replace these batteries,
follow these steps:
1. Remove the cover from the back of the unit.
2. Insert the batteries, taking care to follow their polarity.
3. Replace the cover.
4. Once the batteries have been inserted, the main unit enters "receive" mode in order
to memorise the telecode. When the frame around the telecode flashes, it means
that memorisation is in progress; this will take between three and five minutes. The
main unit will then update the temperature and humidity being read by the remote
unit.
INSTALLING AND CONFIGURING THE TRANSMITTER OR REMOTE TRANSMITTER(S)
On a smooth surface, use the handle attached to the transmitter. The quality of the
surface may however alter the range of the data transmission. If, for example, the
transmitter is placed on a metal surface, the range may be reduced or increased as a
result. For this reason, it is not a good idea to install the transmitter on a metal surface
or anywhere in the vicinity of a large metal surface. Before determining the position of
the transmitter, ensure that the main unit can receive the signals sent by the transmitter.
4
4:21 PM Page 4

REMOTE UNIT

MAIN UNIT

Copyright © Lexibook 2002