Setting The Squelch Level - Icom F2000D 01 Operating Manual

5
USER SETTINGS

Setting the squelch level

The squelch circuit mutes the received audio signal,
depending on the signal strength.
NOTE:
You should turn ON the Beep function (p. 5-2)
before you start setting the squelch level.
1) Rotate [VOL] to turn OFF the transceiver power.
2) Set [ROTARY SELECTOR] to any channel other
than Channel 16.
3) While holding down [Upper], rotate [VOL] to
turn ON the power and enter the squelch level
adjustment mode.
4) Push [Upper] to increase the squelch level (tight
squelch), or push [Lower] to decrease the squelch
level (loose squelch).
• T he adjustable range is 0 (loose squelch) to 9 (tight
squelch).
• A beep sounds after pushing [Upper] or [Lower]. An
error beep sounds if you try to exceed the adjustable
range.
5) Rotate [VOL] to turn OFF the power to exit the
squelch level adjustment mode.
[ROTARY SELECTOR]
[Upper]
[Lower]
5-6
[VOL]