Legal Information - Moog MSD Specification

moog
ID no.: CB08759-001 Date: 03/2023
Specification Option 2 - Technology
TWINsync option
ID no.: CB08759-001 Rev. 1.2
Date: 03/2023
This documentation is applicable to:
Series Model
Hardware version
MSD Servo Drive G392-xxxxx4xxxxx
up to ...3.xxxx.0
Single-Axis System
G395-xxx-x4xxxxx
up to ...3.xxxx.0
MSD Servo Drive G393-xxx-x4xxxxx
up to ...3.xxxx.0
Multi-Axis System
G397-xxx-x4xxxxx
MSD Servo Drive G394-xxx-x4xxxxx
up to ...3.xxxx.0
Compact
Firmware version
up to V2.15 / V201.07 / V230.00

Legal information

Subject to technical change without notice.
This Specification has been prepared based on DIN EN 82079-1. The content was
compiled with the greatest care and attention and reflects the latest information
available to us.
We should nevertheless point out that this document cannot always be updated in
line with ongoing technical developments in our products.
Information and specifications may be subject to change at any time. For information
on the latest version please visit https://www.moogsoftwaredownload.com/msd.html.
Copyright ©
The entire contents of this documentation, especially the texts, photos and graphics it
contains, are protected by copyright. The copyright is owned by Moog unless
specifically marked otherwise.
SpecificationTWINsync module
NOTE
This document is not a substitute for the MSD Servo Drive Operation
Manual. Please be certain to observe the information about "Measures for
Your Safety", "Intended Use" and "Responsibilities" which can be found in
the operation manual. Information about installation, connections,
commissioning and promised technical specifications for the MSD Servo
Drive series can be found in the additional documents (Operation Manual,
Device Help, etc.).
2