Table of Contents
Advertisement
4.
Measure 22" as shown
and tighten fully.
You can cap up the
Corner gussets.
5.
Assemble the adjustable feet at the same height. Make sure to have 2 mirrored
and not all 4 on the same side! Also attach 2X M8 X 16 socket screws and 2X
M8 t-nuts.
4X
6.
With the platform upside down, slide in the feet at every end through the bottom
of the 6" X 50" extrusion. Tighten fully the feet plates with the far edge at around
6" from the end of the chassis.
6
Advertisement
Table of Contents
Need help?
Do you have a question about the ASR Pro and is the answer not in the manual?
Questions and answers