Disconnecting The Dcs Pro Back Plus From The Camera Body - Kodak DCS PRO BACK - USER'S GUIDE Manual

The Basics
Disconnecting the DCS Pro Back Plus
from the Camera Body
1 Place the camera on a table or other flat
surface.
If the DCS Pro Back Plus is being powered by
2
a battery pack, turn the camera off and unplug
the battery cable (page
3 Remove the following cables if they are
connected:
Lens Sync cable
!
Flash Sync cable
!
IEEE 1394 cable
!
(page 61)
S-Video cable (page 86)
!
KODAK PROFESSIONAL DCS Pro Back
!
Plus 503CW/CXi or 553ELX Cable
Assembly
Contents
Back
61).
(page 38)
(page 39)
(page 55) or battery cable
Next
Press the safety release pin (located at the top
4
of the DCS Pro Back Plus Release button).
Slide the DCS Pro Back Plus Release button
5
to the right.
Carefully remove the DCS Pro Back Plus from
6
the camera body.
Index 37