Storage - Scheppach IGT3500 Translation Of Original Instruction Manual

Service information
With this product, it is necessary to note that the following parts are
subject to natural or usage-related wear, or that the following parts are
required as consumables.
Wearing parts*: Spark plug, air filter
* may not be included in the scope of delivery!
Spare parts and accessories can be obtained from our service centre.
To do this, scan the QR code on the cover page.

11. Storage

11.1 Preparation for storage
1. Empty the fuel tank using a petrol extraction pump (see section 11.2).
Warning: Do not remove the petrol in enclosed spaces, near fire or
when smoking. Petrol fumes can cause explosions and fire.
2. Change the oil at the end of every season.
3. To do so, remove the used engine oil from a warm engine and refill
with fresh oil.
4. Remove the spark plug (23). (Fig. 12)
5. Fill the cylinder with approx. 20 ml of oil from an oil can.
6. Pull the start pull cord slowly so that the oil protects the inside of the
cylinder.
7. Screw the spark plug (23) back in.
8. Store the device in a well-ventilated place or area.
11.2 Drain petrol with a petrol extraction pump
In case of storage over a longer period of time, the petrol must be drained.
1. Hold a collection container under the hose of the petrol extraction
pump (not included in the scope of delivery).
2. Unscrew and remove the tank filler cap (2).
3. Remove the fuel filter insert (24).
4. Push the hose of the petrol suction pump into the fuel tank and drain
the petrol completely using the petrol extraction pump.
64 | GB
www.scheppach.com